- First I stripped the wires of both the piezo disk and the connecting wire so the plastic around the metal wires was removed
- then once the wires were exposed I took my hot soldering iron and melted some of the tin allot on to each end of the exposed wire to “tin” them so that they could join together when soldered

3. Once all ends were tinned , I took both ends of each of the ground wires of the piezo disks and soldered them together by melting more tin alloy between the two

4. Then I soldered the black “ground” wires to the wire within the connecting cable without a plastic sleeve ,
this wire is then soldered onto the longest end of the quarter inch jack
5. The red ends of the piezo disks are then each soldered onto one of the sleeved wires in the connecting cable , and these sleeved wires are both connected onto on of the two remaining ends of the quarter inch jack which each connect to one of the ringed sections at the tip of the jack
6. The piezo crystal now will create voltage from pressure , so when sound hits it , a current will be created due to the circuit , allowing the acoustic information to be transmitted into the jack in the form of an electrical current : )
Having used the contact mic , its transformed the way. in which I view recording and using mics , as it’s the first time I’ve used a microphone that doesn’t record vibrations in the air.
I found that I’m able to produce/record textures which a normal microphone wouldn’t be capable of doing so.
An aspect which I find interesting in the mic is its ability to pick up sounds that our ears don’t usually get to hear such as the quiet hum/rumble within a wall or machine. Similarly to highly sensitive condenser microphones , the discovery of the contact mic has allowed for sounds that have never been heard by humans before, to be heard ,which I think is an interesting component to think about when using the recordings produced by them.